Using the Scan Image Engine
1. Tap
2. Point the Dolphin terminal at the bar code.
3. Project the aiming beam or pattern by pressing and
holding one of the following:
•
the SCAN key (all models) or
•
one of the terminal's side buttons (all models).
4. The red LED lights.
5. Center the aiming beam over the bar code; see
Aiming Options
6. When the bar code is successfully decoded, the LED
changes to green and the terminal beeps.
7. The bar code information is entered into the
application in use.
24
> Demos
on page
> Scan Demo
25.