Quick MILL LUCCA M58 Owner's Manual page 6

Direct connect
• This machine has the capability of also being used as a plumbed in unit.
Included with the braided water line are two fiber washers. One washer is to be used
in between the elbow connection of the braided line and where it attaches to the back
bottom of the machine. The other washer is to be used if you will not be using the
provided John Guest fitting. (No teflon tape needed)
• Attach the braided water line to the back bottom of the machine using the provided
fiber washer. Attach the other end to your water source using the provided John
Guest fitting. The machine comes standard with a 3/8" John Guest fitting, but a 1/4"
fitting can also be installed. To use the John Guest fitting the tubing needs to have a
clean rounded cut using a tubing cutter or a sharp razor blade. Then insert the tubing
into the John Guest fitting until it bottoms out.
• If you are not going to be using the John Guest fitting then you will need to use the
additional fiber washer and you will need to purchase a 3/8" male BSPP fitting.
• After connecting both ends of the braided water line, turn on the water supply and
verify there are no leaks.
• Before plugging the machine in, verify the steam and hot water knobs are closed and
the brew lever is in the down position.
• Plug the machine in and turn the main power switch to the on position.
• The boiler filling indicator light will illuminate and the pump will come on to start filling
the boiler. The boiler should fill in approximately 60 seconds. If the pump has not
turned off and finished filling after 60 seconds then turn the main power switch off and
wait 5 minutes.
• After waiting five minutes then turn the main power switch on again. The pump should
come back on to continue filling the boiler. If the pump keeps running for more than
45-60 seconds again then unplug the machine and check to make sure that the water
supply is turned on.
Owner's Manual
LUCCA M58
Page 5