Table of Contents
Advertisement
Non Maskable Interrupt
Button Header
(NMI_BTN1)
(see p.6, No. 20)
Intelligent Platform
Management Bus header
(4-pin IPMB_1)
(see p.6, No. 2)
hermal Sensor Header
(3-pin TR1)
(see p.6, No. 25)
Baseboard Management
Controller SMBus Header
(5-pin BMC_SMB_1)
(see p.6, No. 1)
SCU Connector
(SCU_0-3)
(see p.6, No. 34)
GND
1
CONTROL
GND
No connect
IPMB_SCL
IPMB_SDA
TR1
TR1
1
GND
BMC_SMB_PRESENT_1_N
Power
BMC_SMBCLK
GND
BMC_SMBDATA
EP2C602D16FM
Please connect a NMI device
to this header.
This 4-pin connector is used
to provide a cabled base-board
or front panel connection for
value added features and 3rd-
party add-in cards, such as
Emergency Management cards,
t h a t p r o v i d e m a n a g e m e n t
features using the IPMB.
Please connect the thermal
sensor cable to either pin 1-2
or pin 2-3 and the other end to
the device which you wish to
monitor its temperature.
his header is used for the SM
BUS devices.
The SCU connector support
sSAS/SATA data c ables for
internal storage devices. The
current SAS2/SATA3 interface
a l low s up to 6 . 0 G b/s d at a
transfer rate. For connecting
SAS HDDs, please contact SAS
data cable dealers.
25
Advertisement
Table of Contents
