Using The Toothbrush - Panasonic EW?DE92 Operating Instructions Manual

• It is not possible to whiten the color of teeth beyond their original
color, yellowing teeth due to aging, or discolored teeth.
► About soft start function (For WHITE mode only)
The toothbrush will gradually reach the selected speed and
vibration approximately 2 seconds after it starts operating.
► About the 30-second brushing notification timer function
The timer will signal once at 30‑second intervals to indicate the
brushing time for each part of your mouth. It will signal twice at
2‑minute intervals to indicate the recommended total brushing time.
It is important to brush each area in the same sequence and with
the same amount of time, every time you brush, to uniformly brush
and clean your teeth.
Use the 30‑second brushing notification timer function wisely so
there will be no missed spot in your mouth.
• Divide your teeth into 4 parts (upper
and lower, left and right), and brush
one part in order such as "(1) front of
the teeth", "(2) biting plane of the
teeth", and "(3) back of the teeth"
spending 30 seconds at each part.
Brush the other parts in the same
manner, and brush your whole mouth
in about 2 minutes.
► About mode storage function
This function stores the previously selected mode of operation,
allowing the same mode to be used again.
Mode storage is reset if the unit has discharged and has been
unused for a long period of time, or if the battery has been
completely drained.
After charging, the product starts in WHITE mode, however this is
not a malfunction.
10

Using the toothbrush

• If dried toothpaste or water stains have adhered to the ion panel,
the very weak electric current may be unable to pass into the oral
cavity. Please clean the ion panel.
1
1
(3)
(1) (2)
2
2
Place the brush head firmly onto
the toothbrush shaft.
• As shown in the picture, align the front of
the electrode section of the ionic stain
care brush or silicone brush with the main
unit.
• Attaching or removing diagonally or while
twisting may cause the brush head or the
main unit to become damaged.
• The toothbrush shaft will move when a
force is applied. This is required for
operation, and is not a malfunction.
• There will be a small gap between the
brush head and the main unit.
Grasp the main unit.
• The very weak electric current
may not pass into the oral
cavity if the toothbrush is held
in the same way as a pen so
that your hand does not touch
the ion panel.
Please grasp the main unit as
shown in the figure, so that
your hand comes in contact
with the ion panel.
1