Epic sbc with 3rd generation 22nm intel mobile cpu up to 8.0 gb ddr3, dvi,hdmi, lvds, dual gbe, sata 6gb/s, usb 3.0, pcle mini, intel atm,rohs (191 pages)
No part of this manual may be reproduced by any mechanical, electronic, or other means in any form without prior written permission of the manufacturer. Trademarks EB-5800 is a registered trademark of ICP Electronics Inc. IBM PC is a registered trademark of International Business Machines Corporation.
1 Introduction The EB-5800 takes advantages of CPU board, HDD, power supply and passive backplane for minimum size and slot plug-in connection. It is wireless, and screw less for installation, repair part. It is an IBM PC/AT compatible computer specially designed to meet the applications for Industrial.
1.3 Specifications NOVA-7898 Socket 370 supports Intel P3 Tualatin up to 1.4GHz. System chipset Intel 815E-B step Main Memory Type DIMM DIMM 2 slot, Max. 512MB Chip Intel 82562 and 82559 10/100Mbps Video On-Chip Shaded Memory, DB15 Interface Serial RS232 x2 RJ45 x 2 PS/2 Two ATA 100 channel, 40 pin x1, 44 pin x1...
System Setup The EB-5800 is provided complete kit for your operation. The following sections of this chapter will help your installation and maintenance. 2.1 Assembly Diagram The Rear side of EB-5800 The diagram shows the rear side of EB-5800. For maintenance, installation or upgrade, you have to remove the back cover first by unfastening 2 screws as the diagram shown.
Page 8
The Top/Front View of EB-5800 The diagram shows the front side of EB-5800. The diagram shows two kinds the front side of EB-5800. With LCM and with out LCM EB-5800LCM EB-5800...
2.2 Cabinet Assemble EB-5800 is designed for easy assemble. It is very easy to install the SBC, HDD, Power supply and LCM. To installation shows below. 2.2.1 SBC Installation To install the nova-7898 CPU Board, you have to put the plastic studs into the board then place it into the cabinet and fasten it by two screws.
2.2.2 HDD Installation To install the HDD, you have to assemble the HDD to the HDD bracket first. Then, fasten the HDD bracket to the cabinet by four screws.
2.2.3 Power Supply Installation The standard Power Supply for EB-5800 is ACE-816APS, which is fastened to the power bracket with two screws, and to be installed in the cabinet by fastening three screws as below diagram shown. Please refer the NOVA-7898 manual for power connecting.