Table of Contents
Advertisement
Operation
The menu operations set configurations for the Nexus™ 4x1, including built-in programs to
Menu
operate the Nexus™ 4x1 without a DMX controller. The menu operations are accessed via the
Operations
control panel. For more information, see
Control
Panel.
Setting changes are not activated until the control panel display returns to the home screen. To
return the control panel display to the home screen press and hold <MENU> for 10 seconds.
Auto Show mode allows for dynamic RGB color mixing without a DMX controller. To activate
Auto Show
Auto Show mode do the following:
1. Go to the Auto Show main level.
2. Select the Auto (1–12) or Fade program.
3. Select the Show Speed (000–100).
4. Press <MENU> to return to the homes screen.
Exiting Auto Show
Auto Show mode does not stop when a different operating mode, such as DMX, Art-Net™, or
Kling-Net is selected. To exit from Show mode put the Nexus™ 4x1 into Slave mode. For
Mode
more information see
Master/Slave
. Slave mode does stop when a different operating mode
is selected through the control panel.
Static Color
Static mode selects preset colors or color mixing. To set Static mode do the following:
1. Go to the Static main level.
2. Select Fixture Color or Manual Color.
3. Press <MENU> to return to the homes screen.
For Fixture Color:
1. Select desired color (R, G, B, GB, RB, RG, or RGB).
For Manual Color:
1. Select the desired color (R, G, or B).
2. Select the desired color value (000–255).
3. Repeat the steps for each color.
4. Press <MENU> to return to the homes screen.
Dimmer Mode configures the rate of the intensity change and color change. There are 3
Dimmer Mode
different of dimmer modes with 1 being the slowest and 3 being the fastest. When Dimmer
Mode is set to OFF, the Nexus™ 4x1 fades in direct proportion to the DMX values. To
configure Dimmer Mode, do the following:Go to Dimmer Mode in the main level.
1. Select a dimmer curve (OFF, Dimmer 1, Dimmer 2, or Dimmer 3).
2. Press <MENU> to return to the homes screen.
Back Lite
Back Lite determines how long the backlight on the display stays on. To set the display
backlight on time, do the following:
1. Go to Back Lite in the main level.
2. Select the desired amount of time (in seconds) the backlight display will stay on after
pressing the last menu button (On, 10S, 20S, or 30S).
3. Press <MENU> to return to the home screen.
Nexus™ 4x1 User Manual Rev. 3
-17-
Advertisement
Table of Contents
