Art-Net - Chauvet nexus 4x1 User Manual

Operation

Art-Net™

-20-
To set the Nexus™ 4x1 to Art-Net, do the following:
1. Press <MENU> and then <DOWN>. Ethernet Settings shows in the display.
2. Press <ENTER>.
3. If <Art-Net> shows in the display, go to Step 7 below to configure Art-Net™ settings.
If <Kling-Net> shows in the display, do the following:
4. Press <ENTER>. The words <Kling-Net> start blinking
5. Press <UP> or <DOWN> The words <Art-Net> show and blink.
6. Press <ENTER>. The words <Art-Net> stop blinking.
The Art-Net™ protocol is set. Go to Step 7 below to configure Art-Net™ settings.
Once the Nexus™ 4x1 is set to Art-Net, do the following:
7. Press <DOWN>. Universe < xx> shows..
8. Press <ENTER> the < xx> starts blinking.
9. Press <UP> or <DOWN> until the desired universe number (1–15) shows.
10. Press <ENTER> the < xx> stops blinking.
11. Press <DOWN> Subnet < xx> shows.
12. Press <ENTER> the < xx> starts blinking.
13. Press <UP> or <DOWN> until the desired subnet number (1–15) shows.
14. Press <ENTER> the < xx> stops blinking.
15. Press <DOWN>. Net < xx> shows..
16. Press <ENTER> the < xx> starts blinking.
17. Press <UP> or <DOWN> until the desired net number (1–127) shows.
18. Press <ENTER> the < xx> stops blinking.
19. Press <DOWN>. IP Mode < xxxxx> shows.
20. Press <ENTER> the < xxxxx> starts blinking.
21. Press <UP> or <DOWN> to cycle through the IP options <Manual>, <Static>, <DCHP>.
22. Press <ENTER>.
If <Manual> IP mode is selected, the IP Address shows. To set the IP address, do the
following:
1. Press <ENTER> to move between IP address elements.
2. Press <UP> and <DOWN> to set the numbers within each IP address element.
3. Press <MENU> to confirm the IP address.
Nexus™ 4x1 User Manual Rev. 3