Storage - Weber Spirit E210 CLASSIC Owner's Manual

BURNER TUBE CLEANING
OR REPLACEMENT (continued)
Reinstall Manifold
You will need: A Phillips screwdriver, two 7/16" spanners.
A) Align valves with burner tubes. Using two 7/16"
spanners, install bolts and nuts that secure manifold to
cookbox (1).
B) With a Phillips screwdriver, install screws and washers
that secure manifold to front cross brace (2). If
manifold was properly reinstalled, valves will now be
fully seated inside burner tubes.
CAUTION: The burner tube openings
(3) must be positioned properly over
the valve orifices (4).
WARNING: You should check for
gas leaks every time you disconnect
and reconnect a gas fitting. Refer to
CHECKING FOR GAS LEAKS.
C) Replace cookbox components (not pictured).
Reinstall Control Panel
You will need: A Phillips screwdriver.
A) Align valve stems with holes in control panel. Position
top edge of control panel on tabs of frame assembly.
Push control panel down into position.
B) Fasten control panel with screws.
C) Place control knobs onto valve stems.
D) Connect the wires to the igniter button (5).
WARNING: Make sure that all parts
are assembled and hardware is fully
tightened before operating the grill.
Your actions, if you fail to follow this
product warning, may cause a fire,
an explosion, or structural failure
resulting in serious personal injury or
death as well as damage to property.
28
WWW.WEBER.COM
®
ANNUAL MAINTENANCE
1
2

STORAGE

For grills that have been stored for a while, it is important to follow these guidelines:
gas grill indoors, first DISCONNECT the gas supply and store the LPG cylinder
®
outdoors in a well-ventilated space.
cylinder outdoors in a well-ventilated area.
obstruct the flow of combustion or ventilation air.
3
4
5
® gas grill is not in use.
gas grill, be sure to keep both the grill and the
®