Burner Tube Cleaning Or Replacement - Weber Spirit E210 CLASSIC Owner's Manual

BURNER TUBE CLEANING
OR REPLACEMENT
Confirm that Grill is Off
A) Turn gas supply off at source and disconnect gas
fitting.
B) Check that all burner control knobs are in the off
( ) position. Check by pushing control knobs in and
turning them clockwise until they stop. If they do not
turn, they are already off. If they do turn, continue
turning them clockwise until they stop; then they
are off.
Remove Control Panel
You will need: A Phillips screwdriver.
A) Disconnect the two wires from the igniter located on
the underside of the control panel (1). NOTE: Do not
disconnect by pulling on wires; pull from terminals at
ends of wires.
B) Remove cookbox components (2).
C) Remove control knobs (3).
D) Remove screws from the front of the control panel
with a Phillips screwdriver (4).
E) Carefully lift control panel up and then pull forward and
away from cookbox (5).
Remove Manifold
You will need: A Phillips screwdriver, two 7/16" spanners.
A) With the Phillips screwdriver, remove two screws
and two washers attaching manifold to front cross
brace (6).
B) Using two 7/16" spanners, remove two bolts and two
nuts attaching manifold to cookbox (7). Pull manifold
forward and away from burner tubes (8). Manifold will
remain attached to corrugated gas line(s). Be careful
not to let manifold scratch frame or door or kink the
attached corrugated gas line(s).
24
WWW.WEBER.COM
®
ANNUAL MAINTENANCE
2
4
8
1
3
5
6
7