Burner Tube Cleaning Or Replacement - Weber Q Series Owner's Manual

BURNER TUBE CLEANING
OR REPLACEMENT
Confirm that Barbecue is Off and Cool
A) Turn gas supply off at source and disconnect gas
fitting .
B) Check that all burner control knobs are in the off
( ) position . Check by pushing burner control knobs
in and turning them clockwise until they stop . If
they do not turn, they are already off . If they do turn,
continue turning them clockwise until they stop; then
they are off .
C) Open lid and remove cookbox components .
Remove Burner Tubes
You will need: A 3/8" nut driver .
A) Remove the screw that holds the outside burner tube
to the cookbox (1) .
B) Rotate the outside burner tube 90° to unlock it from
the valve orifice . Slide and lift burner tube away from
valve orifice and remove from cookbox . (2)
C) Repeat this procedure for the inside burner tube (3) .
m CAUTION: Care must be taken when
removing or reinstalling burner tubes.
Do not force or bend the gas lines that
connect the control valves to the burner
tubes (4).
ANNUAL MAINTENANCE
1
2
3
4
WWW.WEBER.COM
35