Configure Dgps; Configure Nmea - Lowrance GlobalMap 4000M Operation Instructions Manual

For assistance in configuring the unit to communicate with another
device, consult the factory; customer service phone numbers are in the
back of this manual. Also see the entries below for Configure DGPS and
Configure NMEA. To set Com Port Configuration:
1. Press
MENU
2. Press ↓ to
C

Configure DGPS

This unit will recognize Starlink
receivers.
1. Press
MENU
2. Press ↓ to
C
A. If you have a Magnavox receiver, press ↓ to
B. If you have a Lowrance or Starlink receiver, press ↓ to
C. If you have a Magnavox or Starlink, press
the only setup necessary. If you have a Lowrance receiver or another
Magnavox- or Starlink- compatible brand, continue with these steps:
3. Press ↓ to
C
, then use ↑ ↓ → ← to enter the station frequency, then
4. Press
ENT
press .
ENT
5. Press → to
B
then press
ENT
6. A. If you are not using a Starlink DGPS receiver, press
| |
EXIT EXIT EXIT
B. If you are using a Starlink DGPS receiver, press ↓ to
|press
T M
UNING ODE
vious page.

Configure NMEA

You can configure the unit to use specific NMEA sentences.
Menus for changing Com Port settings.
| |↓ to
MENU S
P
OMMUNICATIONS
| |↓ to
MENU S
P
OMMUNICATIONS
NMEA
ONFIGURE
then use ↑ ↓ to select the station bit rate,
|
R ENT
IT ATE
.
| to return to the previous page.
EXIT
|press
ENT
|
S ENT
YSTEM ETUP
| .
ENT
ORT

, Magnavox
|
S ENT
YSTEM ETUP
| .
ENT
ORT
|→ to
C
ONFIGURE
| |
EXIT EXIT EXIT
68
.

and Lowrance DGPS
.
|
M ENT
AGNAVOX
S
| |
EXIT EXIT EXIT
| .
DGPS ENT
S
| to return to the pre-
EXIT
.
| .
ENT
TARLINK
. This is
A
TARLINK UTO