To Get To The Gps Simulator; Simulating Trail Or Route Navigation - Lowrance GlobalMap 4000M Operation Instructions Manual

To get to the GPS Simulator:

1. Press
MENU
2. Press ↓ to
GPS S
GPS Setup Menu, left; GPS Simulator menu, right.
Make the desired settings, then turn the simulator on by highlighting
the
GPS S
IMULATOR
to erase this menu. A message and tone appear periodically, warning
you that the simulator is on. To turn the simulator off, repeat the above
steps or turn the unit off.
While in simulator mode, you can press
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, se-
lect the
S
TEER
| |
EXIT EXIT EXIT

Simulating Trail or Route Navigation

In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an approximate
SITION
(shown in compass degrees) that will point you toward the start
T
RACK
of the trail/route.
2. Set to zero. Select
S
PEED
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
press ↑ to increase speed to the desired setting.
| |↓ to
MENU GPS S
|
IMULATOR
box and pressing
O
N
A
WITH RROWS
to return to the previous page.
to clear the alarm.) When navigation starts,
EXIT
|
ENT
ETUP
. The GPS Simulator Menu appears.
ENT
ENT
EXIT
command, press
S A
TEER WITH RROWS
73
.
key. Press
to clear the steering and
ENT
command and press
| |
EXIT EXIT EXIT
, then Press
S P
TARTING
ENT,
O-