Table of Contents
Advertisement
Make the desired settings, then turn the simulator on by highlighting
the
GPS S
IMULATOR
to erase this menu. A message and tone appear periodically, warning
you that the simulator is on. To turn the simulator off, repeat the above
steps or turn the unit off.
While in simulator mode, you can press
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, se-
lect the
S
TEER
|
|
EXIT
EXIT
EXIT
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an approximate
SITION
(shown in compass degrees) that will point you toward the start
T
RACK
of the trail/route.
2. Set
to zero. Select
S
PEED
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
press ↑ to increase speed to the desired setting.
4. Press
to turn off the steering and speed boxes. The unit will now
EXIT
automatically "steer" along the trail or route. When you arrive at your
"destination," cancel navigation as you normally do.
GPS Simulator menu.
box and pressing
O
N
A
WITH
RROWS
to return to the previous page.
S
TEER WITH
to clear the alarm.) When navigation starts,
EXIT
key. Press
ENT
to clear the steering and
EXIT
command, press
command and press
A
RROWS
78
|
|
EXIT
EXIT
, then Press
ENT
S
TARTING
EXIT
P
O-
,
ENT
Hide quick links:
Advertisement
Table of Contents
