Lowrance iWAY 350C Mounting Instructions


For Automotive GPS Receivers
This instruction sheet describes how to assemble and use the quick-
release flexible suction cup mount for Lowrance
ceivers. The flexible suction cup mount is useful for mounting on glass
or other smooth surfaces.
These mounts allow you to make non-mar installations without drill-
ing, screws or permanent adhesives. And, since each mount is portable,
it's easy to transfer the GPS unit to another vehicle.
When a GPS receiver is used in an automobile the driver
is solely responsible for operating the vehicle in a safe
manner. Drivers must maintain full surveillance of all
pertinent driving conditions at all times.
An accident or collision resulting in damage to property,
personal injury or death could occur if the operator of a
GPS-equipped vehicle fails to pay full attention to travel
conditions and vehicle operation while the vehicle is in
motion.
Do not attempt to configure, adjust or enter information
into your GPS unit while driving.
When mounting a GPS unit in an automobile you must
avoid any installation that obscures important instru-
ments and controls or restricts the driver's view through
the vehicle's windows.
Avoid placing the GPS where it could be propelled by an
activated airbag. Some states restrict mounting any
electronic device in any location on an automobile dash.
Be sure to check your local laws before using these
mounts.
Be sure to check the suction mount for adequate adhe-
sion each time you use the unit and reinstall it if neces-
sary.
This is a portable mounting device and the normal heat-
ing and cooling cycle of a car's interior will eventually

Mounting Instructions

W A R N I N G !
1
Pub. 988-0148-992

automotive GPS re-