Table of Contents
Advertisement
step 3: instAlling the Center Wing FAiring
❑ (1) Top Wing with Ailerons
❑ (2) Carbon Fiber Pushrods (Short)
❑ (2) Prebent Wires with Z-Bends
❑ Kwik Bond Thin C/A
❑ # 1 Phillips Head Screwdriver
❑ Wire Cutters
❑ Excel Modeling Knife
❑ Electric or Hand Drill
❑ Cut away the covering material from over the two predrilled center wing
fairing mounting screw pilot holes in the leading edge of the wing.
❑ Apply a couple of drops of thin C/A into the pilot holes and let it dry
completely.
❑ Secure the front of the center wing fairing to the wing, using two M2 x 8mm
wood screws.
❑ If necessary, trim the sides of the cutout in the back of the center wing
fairing to fit around the front of the cockpit.
❑ Press the center wing fairing flat against the surface of the wing, then
use pieces of masking tape to hold it in place.
❑ Install two M2 x 8mm wood screws to secure the back of the center wing
fairing to the wing.
Aileron Control system instAllAtion
you'll neeD the FolloWing pArts From the kit:
you'll neeD the FolloWing tools AnD supplies:
Page
❑ (2) Heat-Shrink Tubing
❑ (2) Plywood Control Horns
❑ (6) C/A-Style Hinges
❑ 1/16" (1.6mm) Drill Bit
❑ Ruler
❑ Pencil
❑ T-Pins
❑ Heat Gun
Advertisement
Table of Contents
