Section One: Assembly Instructions - Traeger BBQ055.04 Owner's Manual

SECTION ONE: ASSEMBLY INSTRUCTIONS

MOUNTING LEGS AND WHEELS:
1. Insert Left Front Leg (119) onto Grill Frame Assembly (3) so the holes align and insert
3 each 1/4-20 x .750 screws (140). Then from the inside of the skirt secure using 3
each Washers (142) and nuts (141) do not tighten the nuts until the grill is upright.
2. Repeat the process for the Right Front Leg (119), Right rear leg (123), and right front
leg (127).
3. Insert Axle rod (131) into holes provided on both right legs (123, 127). Insert Wheel
(136) onto Axle (131) then insert Washer (138) and Nut (139) onto Axle and tighten.
Repeat the process on the other side of the Axle (131).
4. Stand the grill up on its legs and then tighten the leg bolts. Do not over tighten the
Screws.
MOUNTING PELLET HOPPER/BURNER:
NOTE: DO NOT remove the white, square Burner Gasket (86) from the Hopper/Burner (37).
(1) Remove the four hex bolts and washer from the hopper assembly. These will be used
to mount the hopper to the grill body.
(2) Slide the Hopper/Burner (37) square tube into the square opening located on the left
side of the Grill Body (3). Gently push the Hopper/Burner (37) into the Grill Body (3)
until the Hopper/Burner (37) is snug against the end of the Grill Body (3).
(3) Align the bolt holes in the Grill Body (3) with the Nutzerts in the Hopper/Burner (37).
(4) Install a Flat Washer (142) on each of the four Hex Head Bolts (40). From the inside of
the Grill Body (3) install these Bolts with Washers into the Hopper/Burner (37) Nutzerts.
Tighten all four Bolts – DO NOT OVER TIGHTEN THE BOLTS.