Pacific Communications SmartIP-8SD User Manual page 53

- Reverse: Clear the blocks selected within the
selection window and select all unselected blocks
within the selection window.
- Select All: Select all blocks.
- Clear All: Clear all block selections.
- Reverse All: Clear all selected blocks within the
screen and select all unselected blocks within the
screen.
- Trip Direction: Define in which direction the
motion has to occur in order for it to be considered
an event. Select In for movements from outside the
selection area in or Out for movements from inside
the selection area out.
- OK: Save the changes and exit the menu.
- Cancel: Exit the menu without saving the changes.
• Actions: Specify which actions to take when Trip Zone
is detected.
- Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
- Alarm-Out: Designate event-triggered alarm-out
channels and beeps.
- Notify: Configure to be notified of events by Mail,
LAN1 through 5, SNS, and/or Alert Window.
- PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
• Trip Zone Ignoring Time: The system does
not produce event log entries or issues remote
notifications regarding Trip Zone events detected
during the specified time following the initial Trip
Zone event. Set a value between 1 sec and 5 secs or
choose Never.
Trip Zone Ignoring Time does not affect Trip Zone
recording.
• Daytime Setup: Specify when daytime starts and
ends. Adjust the time frame in 15-minute increments.
Times outside the specified range will be assumed as
nighttime by the system.
Tampering
• No.: Select which cameras to apply Tampering to.
• Sensitivity: Set to between 1 (Low) and 5 (High).
• Activation Time: Specify how long tampering
detection needs to last in order for it to be considered
an event. Tampering detections that do not last for
the specified duration of time will not be considered
as events.
• Actions: Specify which actions to take when
Tampering is detected.
- Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
- Alarm-Out: Designate event-triggered alarm-out
channels and beeps.
- Notify: Configure to be notified of events by Mail,
LAN1 through 5, SNS, and/or Alert Window.
- PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
• Use Ignoring Time: Select Time Setup to specify
the tampering detection ignore time. Tampering
detection will be disabled during the specified time
frame.
Part 3 - Configuration
53