Pacific Communications SmartIP-8SD User Manual page 20

Part 1 – Introduction
1 ID Button
Used to assign remote control ID values.
No additional remote control assignment is
necessary if the system's ID is 0. If the system's ID is
a number between 1 and 99, however, you will need
to press the ID button and then press the system
ID number on the remote control. If the system's
ID is set in double digits, press each digit button
consecutively. The
appear on the upper right corner of the NVR screen
(status indication area) to indicate successful system-
to-remote control pairing. If using multiple systems,
it's possible to control all the units with a single
remote control as long as all the system IDs are 0. For
more information on system IDs, refer to the System
Setup on page 36.
2 PANIC Button
Pressing this button displays the
commences recording irrespective of the current
schedule.
Press the button again to deactivate Panic Recording
mode.
3 Camera Buttons
Pressing the Camera button while in Live or Playback
mode displays images from the selected camera in
full screen.
4 STATUS Button
Displays event and recording device statuses.
5 LAYOUT Button
2x2 > 3x3 > 4x4 > 5x5 > 6x6
6 PTZ Control Buttons
Used in PTZ mode to zoom in/out on the screen and
to shift focus between a nearby point and a far away
point.
7 REGISTER MODE Button
Used in Live mode to access Camera Registration
mode.
8 THUMBNAIL Button
Used in Playback mode to access Thumbnail Search
mode. Thumbnail Search mode displays thumbnails
of video recordings and allows you to search
recordings based on date and time parameters. (Will
be supported.)
20
(remote control) icon will
icon and
9 CALENDAR Button
Displays a video recording playback screen that
includes a calendar.
0 KEYLOCK Button
Locks out all remote control keys. To unlock, press the
button again.
! SETUP Button
Displays NVR and IP Camera Setup window and
allows you to search the log.
@ FREEZE Button
Used to pause Live screen.
# LOG Button
Displays system log window and allows you to search
the log.
$ Enter Button
Used to make menu option selections and register
data entries. In addition, pressing the Enter button
while in Live or Playback mode initiates Cameo
mode.
% Arrow Buttons
Used to navigate through menus and interact with
GUIs. In a Setup menu, use the Up/Down Arrow
buttons to increase or decrease numerical values.
In Live or Playback mode, use the Left/Right Arrow
buttons to view the previous or next screen.
^ ALARM Button
Pressing this button while the alarm has been
activated resets all NVR outputs, including the built-
in buzzer. Displays the event log on the screen when
the alarm is off in Live mode.
& SEQUENCE Button
Pressing the SEQUENCE button while in Live mode
initiates Live Sequential mode (displays channels in
sequence).
* ZOOM Button
Used to zoom in on a specific part of the screen. Once
zoomed in, use the arrow buttons to pan around.