Pacific Communications SmartIP-8SD User Manual page 24

Part 2 - Getting Started
2
Specify whether the system is connected to the
Internet and click Next.
If you have chosen No, wait for the test to finish
and then click Finish to exit Network Wizard.
3
Select Network Configuration and then click
Next. Select either Auto Configuration or Manual
Configuration and then click Test to test the
system's current network configuration.
• This test must be performed before proceeding
to the next step.
• If the NVR is on a network connected to a
network that has a DHCP server, selecting Auto
Configuration retrieves LAN settings such as
IP and DNS addresses automatically. Selecting
Manual Configuration, on the other hand, lets
you specify the settings manually.
• UPnP support device not found. If this error
message is displayed, check to see if the IP router
(or NAT) supports UPnP and if UPnP has been
enabled. For more information about the router's
UPnP function, refer to the router's operation
manual.
24
4
Enter in the Device Name field the NVR name to be
registered on the FEN server and then click Check to
check its availability.
• The device name you register on the FEN
server will be a unique name used to identify
the NVR. Once registered, the name can be
used to access the NVR directly from clients
such as the RASplusIP Check the name's
availability to complete the registration
process. The Finish button will then become
activated.
• You will be prompted with an error message if
you do not enter a name for the NVR or enter a
name already registered on the FEN server.
• Depending on the network environment,
FEN services may not be active and therefore
prevent the NVR from connecting to the
network. In this case, you will need to manually
configure the ports. For more information on
port configuration, refer to refer to Network
Setup on page 57.
5
Click Finish to exit Network Wizard.