Table of Contents
Advertisement
Monitoring Options
System
Bootup, Restart,
Shutdown
Panic Record
Check Recording
Check Alarm-In
Disk Almost Full
Disk Full
Disk Bad
Disk Temperature
Disk S.M.A.R.T.
Fan Error
eSATA Disconnected
Disk Config Change
• For system events, only an e-mail notification of actions can be selected.
• In order to use the Notify(Callback) feature, the NVR must be registered to the remote program on the receiving PC's end.
Define monitoring times. If self-diagnosis is not performed on a regular basis, the system
will assume an error.
Define bootup, restart and shutdown actions.
Define panic recording actions.
The system will assume an error if the system has been scheduled to record normally but
recording does not take place during scheduled intervals.
Select Schedule On and then configure the days of the week, times, and monitoring interval.
Select the
button on the bottom left of the screen to add a schedule. Select
delete the schedule.
The system will assume an error if the alarm-in status does not change during the
specified monitoring interval while alarm-in is active.
Generates an event if the disk reaches the specified capacity (80% to 99%).
Generates an event when all disks reach their maximum capacity.
Generates an event when the specified percentage of the disk becomes damaged. Set to
between 10% and 90% in 10% intervals.
Specify the threshold temperature. Once any disk reaches this threshold, the system will
issue an alert.
Monitors disks that support S.M.A.R.T. and notifies the user if a disk error is detected.
Notifies the user when the fan inside the system malfunctions.
Notifies the user if an eSATA device becomes disconnected while in use.
It will be highlighted when the NVR reboots after the hard disk drive has been replaced.
Part 3 - Configuration
icon to
41
Advertisement
Table of Contents
