Miele KM 2354 Operating And Installation Instructions page 25

Stainless steel
surfaces
Pan supports
Control knobs
Burner caps
Burner heads
Ignitor
Ignition safety
device
Cleaning
Clean stainless steel surfaces using an
Original Miele all purpose microfibre cloth or
with a solution of warm water and a little
washing-up liquid applied with a soft sponge.
If required, stubborn stains can be removed
using the rough side of a sponge and a few
drops of the Original Miele ceramic and
stainless steel cooktop cleaner (see "Optional
accessories").
Apply with a light, even pressure following the
direction of the 'grain'. Test an inconspicuous
area first in order to avoid scratching.
The Original Miele care product for stainless
steel can be used after cleaning to help keep
your appliance looking good (see "Optional
accessories"). Apply sparingly with a soft cloth
following the instructions on the packaging.
Remove the pan supports.
Clean in a dishwasher or use a sponge and a
little washing-up liquid with warm water.
If necessary, the reverse side of a
non-scratching washing-up sponge can be
used.
Control knobs should only be cleaned with a
microfibre cloth or with a solution of warm
water and a little washing-up liquid applied
with a soft sponge.
Burner caps should only be cleaned with a
microfibre cloth or with a solution of warm
water and a little washing-up liquid applied
with a soft sponge.
If necessary, the reverse side of a
non-scratching washing-up sponge can be
used.
Burner heads should only be cleaned with a
microfibre cloth or with a solution of warm
water and a little washing-up liquid applied
with a soft sponge.
If necessary, the reverse side of a
non-scratching washing-up sponge can be
used.
The ignitor and ignition safety device should
be very carefully wiped clean using a well
wrung out cloth.
Cleaning and care
Notes
Printed surfaces
(Flame symbols)
The printing can be damaged
if soiling (e.g. food or fluids
that contained salt, olive oil)
is not removed immediately.
Remove any soiling immedi-
ately.
Do not use any stainless steel
cleaner on printed surfaces.
This would rub off the print.
Not dishwasher safe.
Not dishwasher safe.
Not dishwasher safe.
Make sure that the flame slits
are clean and completely dry
after cleaning.
Do not let the ignitor get wet.
If it gets wet, it will not spark.
25