Switching On - Miele KM 2354 Operating And Installation Instructions

Operation

Switching on

In the event of a power cut
18
^ The control for the burner required must be pressed in and
turned anti-clockwise to the large flame symbol to switch
on.
When a control knob is activated, a spark is generated on
all burners. This is not a fault.
^ When the flame ignites, keep the control pressed in for
8-10 seconds, and then let it go.
^ Should the flame be extinguished earlier, turn the control
knob to "ß". Wait at least 1 minute before trying again. If
necessary, keep the control pressed in for longer.
If the burner does not ignite after a second attempt, turn the
control back to "ß" and go to the "Problem solving guide" for
advice.
If there is an interruption to the electricity supply, the gas can
be ignited with a match.
^ Press in the relevant control and turn it anti-clockwise to the
largest flame symbol.
^ Hold the control pressed in and light the gas at the burner
with a match.
Keep the control pressed in for a further 8-10 seconds and
then release it.