Life Fitness 9500 Operation Manual page 10

METS option enable/disable
l
The factory default is set with METS unit display disabled. When you reach Diagnostic State 10
(follow the instruction for Maximum Program Duration Time to enter the diagnostic states), the
Message Center will display "METS OFF". To change the default to ON, press the 5 key and the
system will toggle between OFF and ON.
You may also use the
the METS OPTION.
The ENTER key LED will indicate when the value is set at the default — METS OFF.
Note: When the METS unit display is enabled (METS ON) the far right window of the
message center will show the current resistance level in METS in addition to Watts and
Calories/Hour.
Pressing the CLEAR / PAUSE key repeatedly will exit you out of the diagnostic states.
Pressing the ENTER key will advance you to Diagnostic State 11.
Pause Timeout Duration
l
The Pause Timeout Duration is the amount of time the Cross-Trainer will remain paused after
the CLEAR / PAUSE key has been pressed. The factory default is set for the Pause Timeout
Duration is one minute. You can set this duration to a minimum of one minute or up to a
maximum of 99 minutes.
To do this enter the Diagnostics State 11 (follow the instruction for Maximum Program Time to
enter the diagnostic states) and press the ENTER key until the Message Center displays "PAUSE
TIMEOUT 1". To change the default setting of "1", press the
or increase the pause duration.
The ENTER key LED will indicate when the value is set at the default — PAUSE TIME 1.
Pressing the CLEAR / PAUSE key repeatedly will exit you out of the diagnostic states.
Pressing the ENTER key will advance you to Diagnostic State 12.
key to disable the METS OPTION and the
10
key to enable
key or key to decrease