Troubleshooting - Yamaha PSR-S970 Owner's Manual

Troubleshooting

Overall
A click or pop is heard when the power is turned on or off.
The power is automatically turned off.
Noise is heard from the instrument's speakers.
Noise is heard from the instrument's speakers or headphones
when using the instrument with an iPhone/iPad application.
In the LCD, there are some specific points that are always lit or
unlit.
There is a slight difference in sound quality among different notes
played on the keyboard.
Some Voices have a looping sound.
Some noise or vibrato is noticeable at higher pitches, depending
upon the Voice.
The overall volume is too low or no sound is heard.
The sound is distorted or noisy.
Not all simultaneously played notes sound.
The keyboard volume is lower than the Song/Style playback vol-
ume.
The Main display does not appear even when turning the power
on.
This is normal. Electrical current is being applied to the instrument.
This is normal and due to the Auto Power Off function. If necessary,
set the parameter of the Auto Power Off function (page 17).
Noise may be heard if a mobile phone is used near the instrument
or if the phone is ringing. Turn off the mobile phone, or use it further
away from the instrument.
When you use the instrument along with the application on your
iPhone/iPad, we recommend that you set "Airplane Mode" to "ON"
on your iPhone/iPad in order to avoid noise caused by communica-
tion.
These are the result of defective pixels and occasionally occur in
TFT-LCDs; they do not indicate a problem in operation.
This is normal and is a result of the instrument's sampling system.
The master volume may be set too low. Set it to an appropriate
level with the [MASTER VOLUME] dial.
All keyboard parts are set to off. Use the PART ON/OFF [RIGHT 1]/
[RIGHT 2]/[LEFT] button to turn it on.
The volume of the individual parts may be set too low. Raise the
volume in the BALANCE display (page 57).
Make sure the desired channel is set to ON (pages 56, 65).
Headphones are connected, disabling the speaker output. Unplug
the headphones.
Make sure that the Speaker setting is set to ON: [FUNCTION] 
TAB [E] MENU 1  [J] UTILITY  TAB [E][F] CONFIG 2
The [FADE IN/OUT] button is on, which mutes the sound. Press the
[FADE IN/OUT] button to turn the function off.
Depending on the function assigned to the LIVE CONTROL knob
or how you move the knob, you may not hear the sound properly.
Check the knob settings and reset the value (page 40).
The volume may be turned up too high. Make sure all relevant vol-
ume settings are appropriate.
This may be caused by certain effects or filter settings. Check the
effect or filter settings and change them accordingly, referring to
the Reference Manual.
You are probably exceeding the maximum polyphony (page 110)
of the instrument. When the maximum polyphony is exceeded, the
earliest played notes will stop sounding, letting the latest played
notes sound.
The volume of the keyboard parts may be set too low. Raise the
volume in the BALANCE display (page 57).
This may occur if a USB flash drive has been installed to the instru-
ment. Installation of some USB flash drives may result in a long
interval between turning the power on and appearance of the Main
display. To avoid this, turn the power on after disconnecting the
device.
PSR-S970/S770 Owner's Manual
107