Maxum 3100 SCR Owner's Manual page 56

50 CHAPTER 12: ELECTRICAL SYSTEM
Gas Generator - Starting/Running/Stopping
DOCKSIDE
MASTER
PREHEAT
STOP
START
1. Run the bilge blowers for a minimum of four minutes before starting the generator.
•
The blower switch is located on the AC panel near the generator controls.
•
If your boat is running below cruising speed, leave the blowers on while the generator is running.
2. Make sure the generator's seawater pickup seacock is open before starting and during running of
the generator.
3. Make sure that the battery switch is turned to position "1" or "2".
4. Slide the master breaker lockouts to cover the dockside master breakers and reveal the generator
master breakers.
5. Switch the "GENERATOR LINE ONE MASTER" and the "GENERATOR/LINE ONE TRANSFER"
master breakers on.
6. On the AC panel, press up and hold the oil pressure switch (labeled "PRE-HEAT") and the "START" switch at
the same time until the generator starts.
7. Turn on each individual component breaker as required.
To shut off the generator, press up and hold the "STOP" switch until the generator completely shuts down.
AC PANEL, DUAL SHORE POWER & GENERATOR
BLOWER
MASTER BREAKER
LOCKOUTS
SELECTOR SWITCH
GENERATOR
MASTER SWITCHES