Shore Power - Maxum 3100 SCR Owner's Manual

44 CHAPTER 12: ELECTRICAL SYSTEM

Shore Power

• DO NOT alter shore power connectors and use only compatible connectors.
• Before connecting or disconnecting the shore power cord to your boat, make sure all break-
ers and switches on the AC master panel are turned OFF.
• To prevent shock or injury from an accidental dropping of the "hot" cord into the water,
ALWAYS attach the shore power cord to the boat inlet first; then to the dockside connection.
When disconnecting from shore power, disconnect the shore power cord from the dockside
connection first.
• NEVER leave a shore power cord connected to the dockside connection only.
• Only use shore power cords approved for marine use. NEVER use ordinary indoor or out-
door extension cords that are not rated for marine use.
SHOCK & ELECTRICAL SYSTEM DAMAGE HAZARD!
• Monitor the polarity indicator lights EVERY TIME you connect to shore power.
• When connecting to shore power and you encounter a reversed polarity light (RED col-
ored), DO NOT energize the main breaker switches. Instead, IMMEDIATELY disconnect
the shore power cord (ALWAYS from the dockside receptacle first) and notify marina
management.
SHOCK & ELECTRICAL SYSTEM DAMAGE HAZARD!
• Periodically check the shore power cord(s) for deterioration or damage. NEVER use dam-
aged or faulty cords since the danger of fire and electrical shock exists.
• DO NOT pinch shore power cords in doors or hatches, or coil the shore power cord too
tightly since these situations can generate enough heat to result in a fire.
• If a shore power cord accidently becomes immersed in water, THOROUGHLY dry the
blades and contact slots before reusing.
DANGER!
!
FIRE, EXPLOSION & SHOCK HAZARD!
WARNING!
!
WARNING!
!