Specifications; General Power Tool Safety Warnings; Save All Warnings And Instructions For Future Reference - Makita 4304 Instruction Manual

ENGLISH (Original instructions)
1. Screw
2. Hex wrench
3. Loosen
4. Blade holder
5. Jig saw blade
6. Roller
7. Lever
8. Speed adjusting dial
9. Lock lever

SPECIFICATIONS

Cutting capacities
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
... Read instruction manual.
............. DOUBLE INSULATION
Intended use
The tool is intended for the sawing of wood, plastic and
metal materials. As a result of the extensive accessory
and saw blade program, the tool can be used for many
purposes and is very well suited for curved or circular
cuts.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Explanation of general view
10. Switch trigger
11. Switch lever
12. Base
13. Cutting line
14. Bolt
15. Cross-shaped slot
16. Graduations
17. Edge of motor housing
18. Starting hole
Model
Length of stroke
Stroke per minute
Overall length
Net weight
Wood
Mild steel
Aluminum
Save all warnings and
END201-5
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
ENE019-1
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool. Distractions can cause you
to lose control.
ENF002-2
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
GEA005-3
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet
conditions. Water entering a power tool will increase
the risk of electric shock.
7. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
19. Plastic base plate
20. Anti-splintering device
21. Guide rule
22. Threaded knob
23. Circular guide
24. Pin
25. Fit into notches
26. Plastic cover
27. Vacuum head
4304
26 mm
135mm
10 mm
20 mm
500 – 3,000
249 mm
2.3 kg
4305
26 mm
135 mm
10 mm
20 mm
500 – 3,000
285 mm
2.3 kg
5