Operating Elements - JTS UF-10TH/12 Instruction Manual

Contents
1 Operating Elements . . . . . . . . . . . . . . . . . 10
2 Important Notes . . . . . . . . . . . . . . . . . . . . 11
3 Applications . . . . . . . . . . . . . . . . . . . . . . . 11
3.1 Conformity and approval . . . . . . . . . . . . . . . 11
4 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . 11
4.1 Inserting / Replacing the batteries . . . . . . . . 11
4.2 Switching on / off the microphone . . . . . . . . 12
4.3 Settings via the menu . . . . . . . . . . . . . . . . . 12
4.4 Basic settings . . . . . . . . . . . . . . . . . . . . . . . 12
4.5 Setting the transmission frequency . . . . . . 13
4.5.1 REMOSET
4.5.2 Setting the frequency manually . . . . . . . . 14
4.5.3 Selecting a frequency from a group . . . . 14
4.6 Adjusting the transmission power . . . . . . . . 14
4.7 Adjusting the microphone sensitivity . . . . . 14
4.8 Muting the microphone . . . . . . . . . . . . . . . . 14
4.9 Key lock . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
5 Specifications . . . . . . . . . . . . . . . . . . . . . . 15
Transmission frequencies . . . . . . . . . . . . . . 28
10
® function . . . . . . . . . . . . . . . . 13
All operating elements and connections de -
scribed can be found on the fold-out page 3.

1 Operating Elements

1 Button to switch on / off and to exit a menu
To switch on or to exit a menu, press the button
briefly.
To switch off, keep the button pressed for 2 sec-
onds until the display shows
2 Signal LED
LED keeps flashing in red
when the microphone is muted
LED shows blue for 5 seconds
when the corresponding receiver has set the
microphone to the same frequency via the
REMOSET function (
3 Buttons ▼ and ▲ to select a menu item, to
change settings and to mute the microphone
[keep both buttons pressed for 2 seconds until
the LED (2) starts flashing]
4 Display, showing:
the name of the unit, any name may be selected
(10 characters)
G = the group number (1 ... 12)
C = the channel number (1 ... 60)
MHz = the transmission frequency
(624.000 ... 694.000 MHz))
. . dB = the microphone sensitivity adjusted
(-18 dB ... 12 dB)
= the battery status
5 Button SET to call up the setup menu shown in
fig. 3 (keep the button pressed for 2 seconds until
the menu appears on the display), to call up a
menu item and to save a setting (
6 Screw sleeve for the battery compartment (9)
7 ID cap to distinguish between different micro-
phones: can be removed and replaced by one of
the colour ID caps supplied with the microphone
8 Latch to hold the batteries; to replace the bat-
teries, slide down and fold up the latch
9 Battery compartment
Power OFF
.
chapter 4.5.1)
chapter 4.3)