IKEA FRAMTID HGA5K User Manual page 13

ENGLISH
You can find this label in package sup-
plied with appliance
If the feeding gas pressure will be dif-
ferent or variable, comparing with the
required, you must install an appropriate
pressure adjuster, which is not supplied with
the product and if needed must be ordered
separately from the local After Sales Service
(refer to the Service chapter). The pressure
adjuster must be fitted on gas supply pipe,
in compliance with the rules of the force.
The rating plate is located on the lower cas-
ing of the hob.
Conversion to G2.350 gas
• Auxiliary and semi-rapid burner: after
you assembly the injectors (
ing figure), screw their cages (diameter
10 mm, in following figure) on, inclu-
1
ded in the supply (primary air regula-
tors) ;
• Rapid burner: after assembly the injectors
( in following figure), screw their cages
3
(diameter 16 mm,
on, included in the supply (primary air
regulators) ;
4
in follow-
3
in following figure)
2
1
2
3
Important! In both cases use the special
cap tool and a screwdriver to secure the
4
cages.
Important! Be sure to remove the cap tool
before reassembling the burners.
Adjusting flame level
When hob has been fully installed, it is nec-
essary to check the minimum flame setting:
1. Turn the gas tap to the maximum posi-
tion and ignite.
2. Set the gas tap to the minimum flame
position then turn the control knob from
minimum to maximum several times. If
the flame is unstable or extinguished,
follow the procedure further.
3. Re-ignite the burner and set to mini-
mum.
4. Remove the control knob.
5. To adjust, use a thin bladed screwdriver
and turn the adjustment screw until the
flame is steady and does not extin-
guish, when the knob is turned from
minimum to maximum, and vice versa
(see following picture).
6. Repeat this procedure for all burners.
7. Reassemble the knobs.
Warning! If the appliance is connected
to liquid gas (G31 propane or G30
butane), the regulation screw must be
fastened as tightly as possible.
IKEA of Sweden AB
SE-34381 Älmhult
13