Preparation Using Ground Coffee; Preparing Milk Froth And Warm Milk - Bosch Vero Professional User Manual

Preparation using
ground coffee
This fully automatic espresso machine can
also be operated with ground coffee (not
instant coffee powder).
Drink preparation without milk
À Á
● Select or by turning the knob 6.
● Place the pre-warmed cup(s) under the
coffee outlet 9.
● Open the drawer 20 by pressing.
● Pour in no more than 2 level measuring
spoons 14 of ground coffee.
Warning: Do not use whole beans or
instant coffee.
● Close the drawer 20.
● Press the start button 8.
The coffee is brewed and then dispensed
into the cup(s).
N.B.: Repeat the procedure for another cup
of coffee. If no coffee is taken within 90
seconds, the brewing chamber empties
automatically to avoid overfilling. The appli-
ance rinses.
Drink preparation with milk
● Turn the knob 6 to select Macchiato
Æ
Cappuccino .
● Place the pipe 10d of the milk frother 10
in the milk container 31.
● Swivel the coffee outlet 9 to the right until
it clicks into place.
● Place the pre-warmed cup or glass under
the coffee outlet 9 and milk frother 10.
● Open the drawer 20 by pressing.
● Pour in no more than 2 level measuring
spoons 14 of ground coffee.
Warning: Do not use whole beans or
instant coffee.
● Close the drawer 20.
● Press the start button 8. First milk is
delivered into the cup or glass. After that
the ground coffee is brewed and
dispensed into the cup or glass.
Important: Dried milk residue is difficult to
remove, so clean the milk frother 10 with
lukewarm water immediately after use (see
"Cleaning the milk system").
N.B.: Repeat the procedure for another
coffee / milk drink. If no coffee is taken
within 90 seconds, the brewing chamber
empties automatically to avoid overfilling.
The appliance rinses.
Preparing milk froth
and warm milk
Risk of burns
!
The milk frother 10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
● Place the pipe 10d of the milk frother 10
in the milk container 31.
● Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
● Select the required setting
È
"Milk froth"
turning the knob 6.
● Press the start button 8. Milk froth or
warm milk flows from the outlet of the milk
Å
or frother 10 for about 40 or 60 seconds
respectively.
● Press the start button 8 again to cut the
process short.
Note: When preparing warm milk you may
hear a whistling sound. This is caused by
the milk frother 10 for technical reasons.
Tip: For optimal milk froth quality, use cold
low-fat milk (1.5% fat) if possible.
Important: Dried milk residue is difficult to
remove, so clean the milk frother 10 with
lukewarm water immediately after use (see
"Cleaning the milk system").
en de
É
or "Warm milk" by
33