Table of Contents
Advertisement
915U-2 Wireless I/O
Name
Destination
Next
Hops
IP Gateway
External
Enabled
Save Changes and
Activate.
WIBMesh Configuration
WIBMesh is an extremely efficient proprietary radio protocol used for radio
communications. The protocol is based on the "Ad hoc On Demand Distance Vector"
(AODV) routing algorithm which is a routing protocol designed for ad hoc networks.
There is very little configuration for the WIBMesh as the protocol automatically routes
through the mesh to the destination.
Page 83
IP Routing
A name that describes the routing rule (Max 32 characters).
The destination network or Host IP address. You can specify a
whole network by entering the IP range 192.168.0.0 with a
Netmask of 255.255.255.0 or specify an individual host IP
address.
Specifies the IP address of the next hop router for the
specified destination. Next is the same as destination for the
final hop. Next is the same as destination for one-hop routes.
Indicates the number of routing hops to the destination.
Indicates the Destination acts as a gateway out of the mesh
Indicates that it is routed through a Gateway out side of the
mesh
Check this box to enable the rule. You can Uncheck the box to
disable a routing rule without needing to re-enter the
information at a later time.
Save changes to non-volatile memory, and restarting the
function to load new configuration.
Figure 51 – WIBMesh Configuration Screen
Page 83
915U-2 Wireless I/O
Advertisement
Table of Contents
