Table of Contents
Advertisement
915U-2 Wireless I/O
4.4 System Tools Web page
System Log File
Logs system instructions, etc to the screen where the log screen can be saved to a file.
Not normally used, however maybe used by Technical Support to diagnose problems.
The "Clear System Log" clears the log screen.
Reading Configuration File
Reads the module configuration into an XML file, which can be saved by selecting
"Save As" from the File menu.
Writing Configuration File
Allows a previously saved XML configuration file to be loaded back into the module.
Firmware Upgrade – Web Page
This option allows the module firmware to be upgraded locally. The process is done by
selecting "Firmware update" and then browsing for the saved firmware file.
Locate and load the firmware file, press the "Send" button which will upload the file to
the module and then press the "Reset" button. The module will do some checks to
ensure the file is valid before a reset can be initiated.
Note: All existing configuration parameters will be saved however if any new
parameters are added to the firmware the default values will be used.
Firmware Upgrade – USB
Firmware can also be upgraded by plugging a USB flash drive with the firmware files
installed into the USB port underneath the "Access Configuration Panel" on the side of
the module. The module will automatically identify that a USB drive has been plugged in
and will initiate the upgrade process.
Page 49
Figure 30 – System Tools
Page 49
915U-2 Wireless I/O
Advertisement
Table of Contents
