Table of Contents
Advertisement
Page 44
4.2 First time Configuration
The 915U-2 has a built-in web server, containing web pages for analyzing and minor
modification to the module's configuration. The configuration can be accessed using any
web browser however we recommend using Microsoft
4.2.1 Default IP Address
The default factory IP Address of the 915U-2 is 192.168.0.1XX, where XX is the last two
digits of the serial number (the default "Setup IP address" is shown on the printed label
on the side of the module)
Netmask 255.255.255.0
Username is "user" and the default password is "user"
The 915U-2 will temporarily load some factory-default settings if powered up
with the #6 dipswitch under the side configuration panel switched on. When in
SETUP mode, wireless operation is disabled. The previous configuration
remains stored in non-volatile memory and will only change if a configuration
parameter is modified and the change saved.
Do not forget to set the switch back to the OFF position and re-cycle the power
at the conclusion of the configuration for normal operation otherwise, it will
continue to boot into the default IP address.
4.2.2 Accessing Configuration
The Default IP address is in the range 192.168.0.XXX and so will require a PC on this
network or be able to change the network settings to access the module configuration.
This is the procedure for changing A PC network settings.
You will need a "straight-through" Ethernet cable between the PC Ethernet port and the
915U-2. The factory default Ethernet address for the 915U-2 is 192.168.0.1XX where
XX are the last two digits of the serial number (check the label on the back of the
module).
Connect the Ethernet cable between unit and the PC configuring the module.
Open the side configuration panel and set the #6 Dipswitch to ON.
With this switch on the 915U-2 will always start with the Ethernet IP address
192.168.0.1XX, subnet mask 255.255.255.0, Gateway IP 192.168.0.1 and the radio IP
address 192.168.2.1. Do not forget to set the switch back to the OFF position and
restart the module at the conclusion of configuration.
Page 44
915U-2 Wireless I/O
®
Internet Explorer 8.
915U-2 Wireless I/O
Advertisement
Table of Contents
