Fcc Notice - Elpro Technologies 915U-2 User Manual

915U-2 Wireless I/O

FCC Notice:

This 915U-2 module uses the "E2_900M Wireless Data Modem" radio and complies with
Part 15.247 of the FCC Rules.
Operation is subject to the following two conditions:
This device may not cause harmful interference and must accept any interference received,
including interference that may cause undesired operation.
This device must be operated as supplied by ELPRO. Any changes or modifications made
to the device without the written consent of ELPRO may void the user's authority to operate
the device.
This device must be installed by professional installers in compliance with 47 CFR Part 15
Subpart C Section 15.204 and 15.205, who will be responsible for maintaining EIRP no
greater than 36 dBm in accordance with 47 CFR Part 15 Subpart C Section 15.247 (b)(2)(4).
In accordance with 47 CFR Part 15 Subpart C Section 15.204 only the following
antenna/coax cable kits can be used.
Manufacturer
ELPRO
ELPRO
ELPRO
ELPRO
ELPRO
 Part 15 –This device has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part15 of the FCC rules (Code of Federal Regulations
47CFR Part 15). Operation is subject to the condition that this device does not cause
harmful interference.
 Notice Any changes or modifications not expressly approved by ELPRO could void
the user's authority to operate this equipment.
This Device should only be connected to PCs that are covered by either FCC DoC or are
FCC certified.
Page 3
Model Number
SG-900-6
SG-900-6
SG-900EL
SG-900EL
YU6/900
Coax Kit
CC10/900
CC20/900
CC10/900
CC20/900
CC20/900
915U-2 Wireless I/O
Page 3
Net
5dBi Gain
2dBi Gain
2dBi Gain
-1dBi Loss
4dBi Gain