Insert Rollers; Leveling Bolt Installation; Blower Installation - Lopi Freedom Bay ND Owner's Manual

10

Insert Rollers

Two rollers are built into the back edge of the insert.
This allows the insert to be rolled into position by
lifting the front of the insert and pushing it into
position (see Figure 4).

Leveling Bolt Installation

Two leveling bolts are pre-installed on the insert to
allow for proper leveling within the fireplace. To
access the bolts, remove the back corner firebricks
and cover plates (see Figure 5 "a" and "b") The bolts
are pre-threaded to a weld-nut on the base of the
insert. Use a 3/4" socket wrench to screw the bolts
down (clockwise) until the insert is level (see "c").
MASONRY NOTE: You may wish to place a metal
plate below the bolt if the masonry is weak.
SEALING THE COVER PLATE: We recommend
sealing the cover plate with furnace cement (place on
underside of cover plate).
BOLT LENGTH: The included bolts allow
approximately 1" (26mm) of rise. If additional rise is
required, use a longer 1/2-13 thread bolt. Make sure
the additional bolt length does not interfere with the
cover plate.

Blower Installation

The included blower is fragile and should
be installed last (see the directions to the
right).
© Travis Industries
Installation
(for qualified installers only)
Remove the two
screws underneath the
ashlip. with a 3/8"
nutdriver. Align the
blower under the
ashlip and replace the
two screws to secure.
100-01279
a
Figure 4
b
c
3/4"
Figure 5
4141215