Saving A Program - Dave Smith Instruments Sequential Prophet-6 Operation Manual

PRESET
Toggling off the
preset

Saving a Program

If you've created a sound that you like, you'll probably want to save it.
Saving a program overwrites a previously saved program. Sound design-
ers often save many incremental versions of a program as they continue
to refine it. These intermediate versions often make good jumping off
points for new sounds.
To save a program to the same preset location:
1. Press the
2. Press a
program selector
program.
3. The
write
Be careful when
executing
write
digit, the
write
To save a program to a different bank location:
1. Press the
2. Hold down the
specify the "hundreds" bank of the program. You can only save to
Banks 0-4.
3. Hold down the
to specify the "tens" digit of the program.
4. Press a
program selector
program.
5. The
write
Prophet-6 Operation Manual
button enables "live panel" mode
button. Its LED begins blinking.
write
button LED stops blinking and the program is saved.
is enabled. You can change banks and tens without
write
, but once you press a
command is executed and the program at that location is overwritten.
button. Its LED begins blinking.
write
button then press a
bank
button then press a
tens
button LED stops blinking and the program is saved.
button (0-9) to specify the "ones" digit of the
program selector
program selector
program selector
button (0-9) to specify the "ones" digit of the
button (0-9) for the "ones"
button to
button (0-9)
Getting Started 5