Treadbelt Tracking Adjustment; To Set Treadbelt Tracking - Spirit CT850 Owner's Manual

TREADBELT TRACKING ADJUSTMENT:

The performance of your treadmill is dependent on the frame running on a reasonably level
surface. If the frame is not level, the front and back roller cannot run parallel, and constant belt
adjustment may be necessary.
The treadmill is designed to keep the tread-belt reasonably centered while in use. It is normal for
some belts to drift near one side while the belt is running with no one on it. After a few minutes of
use, the tread-belt should have a tendency to center itself. If, during use, the belt continues to
move toward one side, adjustments are necessary.

TO SET TREADBELT TRACKING:

A 10 mm Allen wrench is provided to adjust the rear roller. Make tracking adjustments from the
left side only. Set belt speed at
approximately 3 to 5 kph.
Remember, a small adjustment can make a
dramatic difference!
Turn the bolt clockwise to move the belt to
the right. Turn the bolt only a 1/4 turn and
wait a few minutes for the belt to adjust itself.
Continue to make 1/4 rotation turns until the
belt stabilizes in the center of the running
deck.
The belt may require periodic tracking adjustment depending on use and walking/running
characteristics. Some users will affect tracking differently. Expect to make adjustments as
required to center the tread-belt. Adjustments will become less of a maintenance concern as the
belt is used. Proper belt tracking is an owner responsibility common with all treadmills.
ATTENTION:
DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER TRACKING /
TENSION ADJUSTMENTS IS NOT COVERED UNDER THE SPIRIT WARRANTY.
CUSTOMER SERVICE 1-888-707-1880
28
EMAIL:
customerservice@dyaco.ca Dyaco Canada Inc. 2014