Operating Status Leds - Cisco C880 M4 Operating Manual

3.Operating and Indicator Elements
3.2.1.

Operating Status LEDs

–
Power supply status LED (green)
–
Ready status LED (green)
–
Fault status LED (amber)
–
Identification status LED
Fault clearing instructions can be found in the
Status LED Color
Power supply Green
Ready Green
Fault Amber
Identification Blue
*:ServerView RAID Manager checks the system status every 60 seconds and it may take nearly this time
until blinking starts for warning (e. g. after removing a HDD). After clearing the error the firmware deletes
the Fault LED, but the RAID Manager may still indicate the old or signal a new warning and activates the
blinking again. When the reason for warning is omitted (e. g. the removed HDD is inserted again), the
RAID Manager stops blinking after a maximum of 60 seconds.
Operating Meaning
ON DC power ON
OFF DC power OFF
ON Normal operation
OFF Not ready
OFF No fault
ON Error detected
Blinking*
ServerView RAID Manager created a warning
status for an error and it should be checked.
Blinking Specifies the enclosure location
chapter "
Fault Clearing" on page 37
of this manual.
13