Cisco C880 M4 Operating Manual page 35

Hide thumbs Also See for C880 M4:
Table of Contents

Advertisement

8.Installation
Figure 25: Position of the cage nuts
Place the cage nuts for fastening the subsystem in the appropriate holes of the front support uprights.
Put the subsystem on the support angles of the sliding rails and push the
subsystem into the rack as far as it will go.
The following steps can be performed by a single person:
Figure 26: Fastening the subsystem (2 units)
Secure the subsystem within the rack using the knurled thumb screws on each side. The left thumb
screw is part of the separate bezel, the right thumb screw is part of the enclosure.
Route the cables.
35

Advertisement

Table of Contents
loading

Table of Contents