Cleaning And Maintenance - Remington EP7020 User Manual

• Place the Detail Cap into the appropriate slots at the top of the epilator.
• Gently press the Detail Cap into place until you hear a "click"
, MASSAGE CAP WITH ALOE VERA:
The Massage Cap is designed for gentler epilation.
• Ensure the epilator is switched off.
• Remove Perfect Angle or Detail Cap.
• Place the Massage Cap into the appropriate slots at the top of the epilator.
• Gently press the Detail Cap into place until you hear a "click"
, SHAVER HEAD:
The shaver head provides a close shave for sensitive areas.
• Ensure the epilator is switched off.
• Press the head release button and remove the epilator head.
• Attach the shaver head until it clicks into place.
• Hold the shaver head at a 90° angle to the skin and move against the direction of hair
growth.
A CAUTION
• For your protection your epilator may slow down or even stop if pressed too firmly
against the skin.
• Do not use the epilating head on irritated skin or skin with varicose veins, rashes, spots,
moles or wounds without consulting a doctor. People with reduced immune response
e.g. during pregnancy, or people who suffer from diabetes mellitus, haemophilia or
immunodeficiency should also consult their doctor before using this product.
• For hygiene reasons do not let another person use your epilator. It is recommended for
use by one person only.
C CLEANING AND MAINTENANCE
To ensure long lasting performance of your epilator, clean the head assembly regularly.
Cleaning the epilation head after each use:
• Ensure the epilator is turned off and disconnected from the mains.
• Press the head release button and open the head assembly. (Diagram F)
• Turn the head assembly upside down.
• The epilator head can be removed and rinsed for cleaning. For optimal cleaning; brush
hairs from the tweezers before rinsing. (Diagram G)
• Allow to dry completely before reattaching the epilator body.
NOTE: The body of the epilator is not washable. The epilator head must be removed prior to
rinsing under water. DO NOT SUBMERGE IN WATER.
To remove residue:
• To remove residue from the stainless steel tweezers, dampen a swab with alcohol.
• Gently run the swab over the tweezers until the residue has been removed.
6