Table of Contents
Advertisement
Ceiling/Wall Mount with Mounting Plate
(Choose this mounting type if you would like to feed the cables from the side)
1. Attach the supplied alignment sticker for the supplied mounting plate to the ceiling/wall.
2. Using the three circles on the sticker, drill three pilot holes (Ø1/4inch x 1.57inch(D)
(Ø6.35mm x 40mm(D))) into the ceiling. Then hammer the three supplied plastic anchors into
the holes.
3. Arrange and feed the cables through the side of the mounting plate.
4. Secure the mounting plate to the ceiling/wall with three supplied screws.
5. Connect the LAN cable to the socket (Refer to the page 14.).
6. Attach the camera main unit to the mounting plate and turn counter-clockwise as shown below.
Then secure three screws on the mounting plate and the supplied screw to fix the camera main
unit to the mounting plate..
7. You will find a silica gel bag attached to the camera. Replace the silica gel bag with the one
shipped within the accessory.
8. Attach the dome cover.
9. Secure the four screws with the supplied torx driver. Make sure all camera parts are securely
installed.
2
1
8
18
4
3
9
6
7
6
Advertisement
Table of Contents
