Table of Contents
Advertisement
AP Deployment
This chapter explains how to mount and connect the Aruba AP 70.
Mounting the Aruba AP 70
When provisioning is complete, mount the Aruba AP 70 at its intended service
location.
The Aruba AP 70 Access Points are intended only for installation in Environment
A as defined in IEEE 802.3.af. All interconnected equipment must be contained
within the same building, including the interconnected equipment's associated
LAN connections.
Select a location as close as possible to the center of the intended coverage area.
If necessary, use the Aruba RF Plan site survey tool to determine the optimum
locations for your access points and air monitors.
The service location should be free from obstructions or obvious sources of
interference. Normally, the higher you place an access point or air monitor, the
better its performance.
3
Aruba AP 70
21
Installation Guide
Advertisement
Table of Contents
