Installing The Feature Enhance Kit; Installation Procedure - Fuji Xerox DocuPrint 3105 User Manual

A.7

Installing the Feature Enhance Kit

This section following describes how to install the Feature Enhance Kit (optional).
Important
• When installing both the Parallel Port Kit (Optional) and Feature Enhance Kit, install the Feature
Enhance Kit first.
Note
• The HDD Extension Kit (optional) is required when installing the Feature Enhance Kit.

Installation Procedure

1. Switch the power off by pressing the <
side of the power switch of the printer.
After checking that the display of the control
panel and the various lamps have switched
off, unplug the power cord from the power
outlet and the printer.
Important
• The electric parts on the inside of the right cover of the
printer can get very hot. Before installing extension
system memory, be sure to first switch off the power of
the printer, wait for approximately 40 minutes, and
check that the temperature inside the printer has
cooled down.
2. Loosen the screw of the rear panel of the
printer, slide the right cover backward, and
remove the cover by pulling the lower side
of the cover towards you.
Feature Enhance Kit ROM
>
A.7 Installing the Feature Enhance Kit
337