Replacing The 200K Maintenance Kit - Fuji Xerox DocuPrint 3105 User Manual

Replacing the 200k Maintenance Kit

When the 200k Maintenance Kit
displayed on the control panel display. Purchase the 200k Maintenance Kit, and install it on
the printer by following the installation procedure.
*: 200k Maintenance Kit consists of the Nudger Rollers, Tray feed Rollers, Tray Retard
Rollers, and Transfer Roll.
Ready
Replace Tray Feed Roller
Ready
Replace Transfer Roll
Replacement Procedure (Tray Feed Roller Unit)
 Tray Retard Roller
1. Switch the power off by pressing the <
side of the power switch of the printer.
After checking that the display of the control
panel and the various lamps have switched
off, unplug the power cord from the power
outlet and the printer.
Important
• The electric parts on the inside of the right cover of the
printer can get very hot. Before installing extension
system memory, be sure to first switch off the power of
the printer, wait for approximately 40 minutes, and
check that the temperature inside the printer has
cooled down.
2. Pull out the paper tray from the printer.
Check the retard roller.
252
7 Maintenance
*
replacement time approaches, the following message is
Message
*1
The Tray Feed Roller needs to be replaced.
Refer to " Replacement Procedure (Tray Feed Roller Unit)"
(P. 252) to replace the Tray Feed Roller.
The Transfer Roll needs to be replaced.
Refer to " Replacement Procedure (Transfer Roll)" (P. 257) to
replace the Transfer Roll.
>
Action
Tray Retard Roller