XBOX ClubSport Fanatec Manual page 11

PC Mode (also for PS4): By default the wheel base will switch to Xbox One
mode after initialisation and auto calibration is finished.
To use the wheel base with attached Universal Hub for Xbox One on a PC or on
PlayStation 4 console you have to switch to PC mode by pressing the buttons
at the same time.
The PC mode is indicated by red lit ring of light around the wheel base
START button as shown on picture on the right hand side:
PS3 Mode: By default the wheel base
will switch to Xbox One mode after in-
itialisation and auto calibration is fin-
ished.
For use on PlayStation 3 console the wheel base with attached Universal Hub
for Xbox One must first be switched to PC mode as above and then must be
switched to PS3 mode
by pressing the buttons at the same time.
The PS3 mode is indicated by white lit ring of light around the wheel
base START button and by red dot on the tuning display of the Univer-
sal Hub for Xbox One as shown on pictures on the right hand side:
To exit PS3 mode it is necessary to restart the base (switch off and on again).
Shifter Calibration Mode: To enter
the H-pattern shifter calibration mode
press <MENU> + <tuning menu> at the
same time: Put the H-pattern shift- er
into the position shown on the tuning
display and acknowledge each single
position by pressing <MENU> to get to
the next one:
11