Assembly & Installation; Handle Assembly; Installation - NewAir CC-280E Owner's Manual

ASSEMBLY & INSTALLATION

HANDLE ASSEMBLY

Tools Required for Assembly: Phillips screwdriver (not included)
Estimated Assembly Time: 5 minutes
Before installation, attach the handle to the front of the unit with the included
screws. It may be necessary to push aside the rubber seal on the inside of the
door to reveal the screw holes.
Caution: Avoid over-tightening the screws, or you may cause damage to the
unit.

INSTALLATION

This cooler is a freestanding unit and should not be installed inside a cabinet or
other built-in enclosure.
For proper ventilation, allow 5 inches clearance between the back of the unit
and any adjacent walls.
Before operating your wine cooler for the first time, follow these steps:

Before connecting the unit to a power source, allow it to stand upright for
approximately 2 hours. This will reduce the possibility of any system
malfunctions which may have occurred from handling during
transportation.

Clean the interior surface of the unit with lukewarm water and a soft cloth.

Place the cooler on a level surface that will be strong enough to support
the unit when it is fully loaded. To level your cooler, adjust the front feet
located at the bottom of the unit.

Install the cooler away from direct sunlight and heat sources such as
stoves, heaters, or radiators. Direct sunlight may affect the unit's acrylic
coating, and nearby heat sources can increase electrical consumption.
Extreme cold or hot ambient temperatures may also prevent proper
performance.

Please note: this cooler is only designed for home use, and is not designed
to be placed in a garage, basement, or outdoor area.
6
http://www.NewAir.com