Assembly Instructions; Initial Setup; Installation Of Your Appliance - NewAir AWB-360DB Owner's Manual

ASSEMBLY INSTRUCTIONS

INITIAL SETUP

Remove exterior and interior packing materials and connect the wine and
beverage cooler to a power supply. Once it is plugged in, let it run for at least
30 minutes. Do not change the temperature or adjust any settings at this time.

INSTALLATION OF YOUR APPLIANCE


Use two or more people to move and install the appliance. Failure to do so
can result in back or other injury.

Place your appliance on a floor that is strong enough to support it when it
is fully loaded.

Choose a well-ventilated area with temperatures above 60℉ and below
90℉.

This appliance is designed for built-in, recessed or free standing
installation.

For built-in installation, leave a 1/4" (6.35mm) space on each side and at
the top of the appliance to ensure proper air circulation to cool the
compressor and condenser.

For freestanding installation, leave the proper clearance around the
appliance. Below are the recommended clearances:
Side: 3/4" (19mm); Top: 4" (100mm); Back: 2" (50mm)

Even for built-in installation, you must keep space on each side and at the
top. If you plan to use the unit for a built-in application please follow the
requirements shown below.
Cabinet Opening Dimensions (minimum)
Width
Depth
Height
http://www.NewAir.com
6
24"
25"
35"