Assembly & Installation; Handle Assembly; Installation - NewAir AWR-520SB Owner's Manual

1. NTC point
2. Light switch
3. Temperature
display
4. Light
5. Temperature
switch
6. Temperature
setting
ASSEMBLY & INSTALLATION

HANDLE ASSEMBLY

Tools Required for Assembly: Phillips screwdriver (not included)
Estimated Assembly Time: 5 minutes
Before installation, attach the handle to the front of the unit with the included
screws. It may be necessary to push aside the rubber seal on the inside of the
door to reveal the screw holes.
Caution: Avoid over-tightening the screws, or you may cause damage to the
unit.

INSTALLATION

Before connecting the appliance to a power source, let it stand upright
for approximately 2 hours. This will reduce the possibility of a
malfunction in the cooling system from handling during transportation.
This appliance can either stand alone or be built in. Front grille must be
unobstructed.
Before operating your wine cooler for the first time, follow these steps:

Clean the interior surface of the unit with lukewarm water and a soft
cloth.
NEWAIR AWR-520SB 52 BOTTLE BUILT IN COMPRESSOR WINE COOLER
7. Fan
8. Exhaust
window
9. Shelf
10. Body
11. Exhaust
window
12. Foot
13. Glass
14. Door seal
15. Handle
16. Lower hinge
6