Assembly & Installation; Handle Assembly; Installation - NewAir AWB-400DB Owner's Manual

ASSEMBLY & INSTALLATION

HANDLE ASSEMBLY

Tools Required for Assembly: Phillips screwdriver (not included)
Estimated Assembly Time: 5 minutes
Before installation, attach the handle to the front of the unit with the included
screws. It may be necessary to push aside the rubber seal on the inside of the
door to reveal the screw holes.
Caution: Avoid over-tightening the screws, or you may cause damage to the
unit.

INSTALLATION

Before connecting the appliance to a power source, let it stand
upright for approximately 2 hours. This will reduce the possibility
of a malfunction in the cooling system from handling during
transportation.
This appliance can either stand alone or be built in. The front grille must be
unobstructed.
Before operating your wine/beverage fridge for the first time, follow these
steps:
•
Clean the interior surface of the unit with lukewarm water and a soft cloth.
•
Place the fridge on a level surface that will be strong enough to support
the unit when it is fully loaded. To level your fridge, adjust the front feet
located at the bottom of the unit.
•
Install the fridge away from direct sunlight and heat sources such as
stoves, heaters, or radiators. Direct sunlight may affect the unit's acrylic
coating, and nearby heat sources can increase electrical consumption.
Extreme cold or hot ambient temperatures may also prevent proper
performance.
7