Before Using Your Wine Cooler
Remove exterior and interior packing materials.
Make sure the following parts are included with the appliance:
‐ 14 slide‐out shelves
‐ Instruction manual
Before connecting the wine cooler to a power supply, let it stand upright for approximately 2 hours.
This will reduce the possibility of malfunction that may have occurred from handling or transport.
Before using this wine cooler for the first time, clean the interior with a soft cloth and lukewarm water.
Place the appliance on a level floor surface that will be strong enough to support it when it is at full
capacity. To level the wine cooler, adjust the front leveling feet located at the bottom of the appliance.
Keep this wine cooler away from direct sunlight and excess heat sources such as stoves, heaters,
radiators, etc. Direct sunlight may damage the unit's acrylic coating while heat may increase electricity
consumption. Extreme hot or cold ambient temperatures may also affect performance.
PLEASE NOTE: This wine cooler is only designed for home use. Do not use it in a garage or basement.
Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged, have it replaced by an authorized Products service center.
This unit should be properly grounded for your safety. The power cord is equipped with a 3‐prong plug
which is compatible with 3‐prong wall outlets. This is to minimize the possibility of electrical shock. Do
not, under any circumstances, cut or remove the ground wire from the supplied power cord.
Do not use an extension cord with this appliance.
This unit requires a standard 110V ~ 60Hz electrical outlet with a 3‐prong plug.
To prevent accidents and/or injury, the power cord should be secured behind the wine cooler and not
left exposed or dangling.